Set-up your Tespo Connect dispenser

Setting up your dispenser is fun and easy. 

• Un-box your dispenser and place near a power outlet.

- Note your WiFi Network name & WiFi Network password is located on the inside of the box, do not recycle just yet, it is also located on the bottom of your dispenser and inside the pod storage door. 

       

1. Unpack the Tespo Power cord - Plug the Tespo power cord into the back of the Tespo dispenser first; then, plug the power cord into your wall outlet. (LEDs will light up)

       

1. Download the TespoHealth App from the App Store or Android PlayStore
2. Open the TespoHealth App and SignUp/Register by following the screens
3. Once you've signed up go to settings>Dispensers>Add a new dispenser ( you will need your Wifi network and password for this part)
4. Wait for the Tespo WiFi LED to turn green before moving to the next steps
5. Fill water tank with clean drinking water to remove low water readings. (do not use hard water or well water)

• Note your water tank is not removable/detachable

6. Unpack the Tespo Cup - Place the Tespo cup centered onto the magnetic cup mixer.
7. Lift the clear lid, place your Tespo Pod foil side down into the Tespo dispenser, firmly click Pod down into place. DO NOT REMOVE THE BARCODE FROM THE POD
8. Close the clear lid and wait for the “GO” button to turn green (your dispenser is reading the pod)
9. Press the “GO” button when you are ready to mix your Tespo serving.

• Note: The Tespo mixing cycle varies per formula

10. Once your Tespo cup stops spinning, remove the cup and enjoy your vita-shot!